OPERATION OF CYCLO MIXER Make: IKA

• OBJECTIVE:

• To lay down the procedure for operation of Cyclomixer. Make: IKA

• SCOPE:

This SOP is applicable to the procedure for Operation of Cyclomixer. Make: IKA at {Company Name} {Location}.

• RESPONSIBILITY:

• Officer/Executive/Designee Quality Control – Shall be responsible for operation as per SOP.
• Head/Designee Quality Control – Shall be responsible for ensuring compliance as per SOP.

• ACCOUNTABILITY:

             QA Head shall be Accountable for implementation of SOP.

• PROCEDURE:

• Ensure that the instrument is clean and free from dust.
• Set up the cyclo mixer in a spacious area on an even, stable, non-slip and fire proof surface. Switch “ON” the mains
• Note: Ensure that the power cord is connected to the power socket.
• Place the Volumetric flask or test tube containing a mixture of sample which shall be mixed on vibrator.
• Select the mode of operation Direct on/Load.
• Direct on: By this the vibrator will start directly & the regulator can control speed
• Load: By this means the unit will start only when the rubber top is loaded by tube with gentle press on the rubber top.
• Position the knob desired mode and gradually increase the speed by rotating the knob clockwise.
• If the shaking movement of the mixer increases (resonance), reduce the speed or pass through the critical phase as quickly as possible.
• Reduce the speed by using rotating the knob anti clockwise if
• The medium splashes out of the vessel because the speed is too high.
• The mixer is not running smoothly.
• After completion of mixing switch “OFF” the mains.
• Precautions:
• Keep the sample containers as vertical as possible.
• Do not operate the appliance in an explosive atmosphere, with hazardous substances or under water.
• Always disconnect the plug before fitting the accessories.
• Position one single shaking vessel in the center and several shaking vessels so that they are evenly spread out.
• The appliance is not suitable for manual operation.
• REFERENCES:

Not Applicable

• ANNEXURES: 

Not Applicable

        ENCLOSURES: SOP Training Record.

•  DISTRIBUTION:

• Controlled Copy No. 01  :          Head Quality Assurance
• Controlled Copy No. 02  :         Head Quality Control
• Master Copy                    :          Quality Assurance Department

• ABBREVIATIONS:

• REVISION HISTORY:             

CHANGE HISTORY LOG